Water damaged cabinet boxes under the sink
We find the leak source, replace the damaged cabinet base and side panels, treat any mold, and reseal the sink and disposal connections so it does not come back.
As a kitchen renovation contractor Nashville TN homeowners call for full tear-outs and cabinet-to-counter refreshes, we handle permits, demolition, and finish work under one roof. Whether your 12South bungalow needs a galley layout opened up or your Green Hills kitchen is due for quartz and shaker cabinets, our crew works clean and keeps you informed. Call (615) 909-7503 for a same-week estimate.

A kitchen renovation contractor Nashville TN is the licensed trade that tears out old cabinets, reworks plumbing and electrical, and rebuilds your kitchen to code from the studs out. That means framing changes for an open plan, new circuits for a range hood and under-cabinet lighting, cabinet and countertop installation, and the finish work that ties it together. We pull the Davidson County permits, coordinate the trades, and stay on site until the punch list is closed.
Most Nashville kitchens we walk into were built 20 to 40 years ago, and they show it: worn out cabinets, cracked countertops, and a leaky kitchen sink that has quietly rotted the cabinet boxes. Older homes near East Nashville and Woodbine often have undersized electrical service and poor ventilation and range hood issues that fail inspection once walls open up. Hiring a kitchen renovation company Nashville TN that knows the local building stock saves you from surprise change orders mid-demo.
Every full kitchen renovation we quote covers the work below. Cosmetic add-ons like a smart kitchen remodel or a kitchen makeover can be scoped separately if you want to phase the project.
We remove old cabinets, counters, flooring, and backsplash, protect the surrounding rooms with dust walls, and haul debris out daily so your house stays livable during the tear-out.
We reroute supply and drain lines for the new sink and appliance layout, add circuits for the range hood, disposal, and under-cabinet lighting, and bring everything to NEC and IRC standards before inspection.
We set the cabinet run level and plumb, install soft close hinges and drawer glides, template the countertop on site, and cut the undermount sink opening to spec so the seal is watertight.
Ceramic tile backsplash, subway tile, porcelain tile flooring, or luxury vinyl plank go in level and sealed. We level the subfloor first so the finish lays flat and stays flat under foot traffic.
LED under cabinet lighting on a dimmer, task lighting over the island, and a properly ducted range hood sized to the range. We run rigid duct to the exterior so grease and moisture leave the house.
We pull the Davidson County permits, schedule the rough-in and final inspections, and hand over the signed-off paperwork so the work is documented for resale and insurance.
We measure the room, photograph the panel and plumbing, and check for water damaged cabinet boxes and mold behind backsplash. You get a written scope and a realistic 2026 price range within 48 hours, not a vague ballpark.
You pick cabinet style, countertop material, and flooring with our lead, and we spec the brands that fit your budget, from Merillat and Thomasville up to KraftMaid and Cambria. We lock the layout, order long-lead items, and confirm the permit set.
We pull the Davidson County Contractor License permits, then protect the floors and dust-wall the work zone. Demolition takes one to three days, and we haul debris out daily so your house stays livable.
Plumbing, electrical, and HVAC rough-in get inspected before drywall goes up. Then cabinets, countertop template, tile backsplash, and flooring go in, with the same crew lead on site every day to answer questions.
We test every outlet, run the disposal and dishwasher, check the range hood draw, and adjust soft close hinges and drawer glides. You get a punch list walkthrough, a workmanship warranty, and a clean kitchen the day we hand back the keys.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
Precision cuts on cabinet trim, filler strips, and crown molding so the joints close tight and the finish reads seamless.
We set the cabinet run level and plumb and locate framing before we cut, so the layout is right before a single screw goes in.
Clean cuts on ceramic tile backsplash and porcelain tile flooring, and a consistent bead of sealant at every wet edge.
Clamps hold cabinet boxes tight while the glue sets, and the lift lets us hang drywall cleanly on ceiling repairs after the rough-in.
Detail cuts around outlets, the sink opening, and the range hood duct, done clean so the finish covers the cut.
A cramped galley kitchen in a 1940s East Nashville bungalow with worn out cabinets, a cracked laminate counter, one overhead light, and a leaky kitchen sink that had rotted the cabinet base.
We rebuilt the cabinet run with shaker cabinets and soft close hinges, installed quartz countertops with an undermount sink, added a ceramic tile backsplash and LED under cabinet lighting, and brought the electrical up to code. The kitchen went from 8 linear feet of usable counter to 14.
A closed-off 1990s kitchen in Green Hills with a wall separating it from the dining room, dated oak cabinets, and a recirculating range hood that left grease on the cabinets.
We confirmed the wall was load-bearing, installed a beam, and opened the space into one room. New KraftMaid cabinets, granite countertops, and a ducted range hood vented to the exterior went in, along with hardwood flooring matched to the adjacent room.
A small kitchen in The Nations with dead corner cabinets, a failing kitchen faucet, and a broken garbage disposal. The homeowner wanted more storage without moving walls.
We installed full-height cabinets with corner pull-outs, replaced the faucet with a Delta pull-down, swapped the disposal, and added a butcher block countertop over the new cabinet run. Usable storage went up roughly 35 percent in the same footprint.
Most kitchen calls start with one visible problem and end with two more behind the wall. Here is what we find and how we fix it.
Ask a pro →We find the leak source, replace the damaged cabinet base and side panels, treat any mold, and reseal the sink and disposal connections so it does not come back.
We redesign the layout with full-height cabinets, corner pull-outs, and a proper work triangle, then build it so the storage you paid for is storage you can reach.
We duct the hood to the exterior, add LED under cabinet lighting and task lighting over the island, and put the whole kitchen on dimmers so it works day and night.
We check the subfloor for level and moisture, repair or replace the damaged sections, and install an underlayment before the new flooring goes down so the finish stays flat.
A mid-range full kitchen remodel in Nashville runs $28,000 to $75,000 in 2026, with cosmetic refreshes starting around $12,000. Cabinet replacement, countertop material, and layout changes drive most of the cost. We give you a line-item estimate after the walkthrough so you can see where the money goes before you commit.
The best contractor is the one who pulls permits, shows you a license and insurance certificate, and puts the scope in writing. Ask for the NARI or NKBA credentials, check the Tennessee Home Improvement License, and call two recent references. We hand over all of that on the first visit, plus a workmanship warranty.
Get three written estimates on the same scope, verify the license and insurance, and confirm who pulls the permit. Ask how change orders are priced and who the crew lead will be. We walk you through all of it on the estimate visit, and you get the crew lead's name before you sign anything.
We handle demolition, framing changes, plumbing and electrical rough-in, cabinet and countertop installation, tile, flooring, and finish work, plus the permits and inspections. We coordinate the trades so you have one point of contact. Most full remodels take six to ten weeks depending on cabinet lead times.
Call (615) 909-7503 and we will schedule a walkthrough this week. You get a written scope, a line-item price, and a crew lead's name before any work starts. Licensed, insured, and permitted in Davidson County.
Get a Free Estimate (615) 909-7503 →Call (615) 909-7503 or email [email protected] and we will set up a walkthrough. We answer the phone during business hours and keep the 24/7 line open for emergencies. Most estimates get scheduled within a few business days, and we give you a written number before any work starts.